This in-ground Pet fencing system is the most reliable, humane & cost-efficient pet containment system available today.
Helps keep your dog safe from dangers and traffic while allowing them free access to contained areas. A radio transmitter connected to a power outlet emits a radio signal along an underground wire. When your dog approaches the wire boundary, the radio signal will initiate the collar to issue the warning beep first. If your dog continues to move closer to the boundary, the system will issue a mild shock. If your dog continues further, the system will issue stronger shocks until your dog returns within the boundary you have set up. Your dog will naturally seek to avoid correction, remaining content with staying within the designated areas. Restricted areas can be easily combined or deactivated at your control.
SYSTEM FEATURES:
- Wireless & Intelligent Containment System - The transmitter emits a harmless radio signal along the underground wire to initiate the warning signals to the dog when it moves close to the boundary.
- Flexible Containment Design - The looping system is able to be based on their actual environment.
- Multiple Dog Training System - The fence system works with multiple dogs at the same time.
- Dangerous or Protection Area Entry Prevention - Allows the enclose of a specific dangerous or protected area such as swimming pools or gardens and makes sure the dogs cannot enter.
- Pulsed Proportional Stimulus - The closer the distance between your pet & the boundary, the more intense the static shock.
- Progressive Tone Stimulus - Gradual warning signals will be issued at different stages, i.e. a warning tone will be issued first, then a shock stimulus if your dog continues to move closer to the boundary.
- Power Boost Switch - The width of the warning can be adjusted through the field width adjustment knob in the transmitter.
- Speed Detect Anti-Run Through - The faster your dog is moving, the quicker the high level of intensity is issued. The collar automatically increases the stimulation when your dog continues more than 1/3 of the way through the containment field, regardless of the transmitter stimulation level setting.
- Audio Wire Break Alarm - The system's control center has an audible alarm to alert you if it senses a break in the wire or if the boundary system is not functioning correctly.
- Visual Wire Break Alarm - The system's control center will light up if it senses a break in the wire.
- Quick Disconnect Terminals - Quick and secure connection or disconnection of the wire to the control center.
COLLAR FEATURES:
- Sturdy nylon collar with length adjustable from 30 to 55cm (approx. 12 to 22 inch) for different dog sizes ( Other collars can be fitted with a width of 2 cm (0.75 inch)).
- The collar has a battery indicator (LED) displaying the battery status, i.e. GREEN for working properly, RED for battery replacement is necessary.
SETUP:
- 1. Dig a trench with a 1"-3" depth and lay the wire along the perimeter you chosen. The wire must be in a continuous loop from the transmitter and back again.
Notes: - DO NOT bury the wire until you have made sure that the system is running properly
- Use a gradual turn at the corners with a minimum of 2.5 foot radius, this produces the mosy consistent containment field.
- 2. Install the transmitter box on the wall and connect with the wire set up in a complete loop.
- 3. Turn on the power source to check whether the wire loop is in good condition or not ("OK" LED light means the loop system is complete and ready for use, "BREAK" LED light means the loop system is incomplete and you should check the connection and wire status again.)
- 4. Insert battery into the collar and put it on your dog.
- 5. Train your dog by leading him around the perimeter. Let him experience the warning beeps & shock so that he knows his boundaries.
- 6. Bury the wire after the system has been checked to be in normal working condition and then place the training flags with recommended 10' flag-flag interval as a visual cue for your dog.
- 7. Enjoy your FENCING SYSTEM.
Specifications:
- Indoor wall-mounted transmitter Dimension (L x W x H): 12 cm x 9 cm x 3 cm
- Training Flags Length: 19 cm
- Battery: 4LR44 6V (included)
- Power Cord Length: 180 cm
Package Included:
- 1 x Indoor wall-mounted transmitter
- 1 x AC Power Adaptor (Input: 100-240V AC 50-60Hz; Output: 12V DC)
- 1 x Adjustable receiver collar
- 1 x 6 Volt (4LR44) battery for the collar
- 1 x Boundary wire of 300 meters
- 20 x Training flags
- 1 x Test bulb
- 4 x Screws
- 1 x User's manual